Axiohm 7156 Spezifikationen PDF herunterladen (Seite 38)

Setting Up and Using the Printer 7156 Owner’s Guide

October 199530

Testing the Printer

Test the receipt station using the simple tests described in this section. To further

test the receipt station or to test the slip station, run the level 1 diagnostic tests

described in “Level 1 Diagnostics” in the “Diagnostics” chapter later in this book.

See “Solving Problems” later in this book for what to do if the printer is not

functioning properly.

The tests print various settings which can be used to check the printer's

configuration. Give this to a service representative if there is a problem. The

settings are listed in “Level 1 Diagnostics.” The tests also print all variations of

the character set with a partial cut between each variation. See the samples at the

end of this chapter. The tests end with a partial cut, then begin again. Several feet

of paper can be used to print one pass of the test.

Running the Print Test by Power Cycling the Printer

1. Press and hold down the Paper Feed button on the top panel.

2. Press the On Line button.

3. Let go of the Paper Feed button once the printing begins.

The printer begins printing the data and character sets (see the sample).

4. To stop the test, press the Paper Feed button.

The printer is ready to receive and print data from the host system.

Running the Print Test by Opening and Closing the Cover

1. Open the receipt cover by pulling up on the front left side of the cover.

The LED (red) comes on indicating the receipt cover is open and that the

printer cannot receive or print data (not that the paper is out).

2. Press and hold down the Paper Feed button while closing the receipt cover.

3. Let go of the Paper Feed button once the printing begins.

The printer begins printing the data and character sets (see the sample).

4. To stop the test, press the Paper Feed button.

The printer is ready to receive and print data from the host system.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 189 190

Keine Kommentare

Axiohm 7156 Spezifikationen Seite 38